Building Solar Panels for Dummies!

A revolutionary change is sweeping across the world and the U. S. As more and more people are generating energy naturally than through carbon generating methods. You too can learn how to build solar panels in your own home as an experiment to see how this renewable source of energy can cut down expenditure.

The advantage of this experiment is to learn about something first-hand what one has only read about. This way you will know what it is for yourself. And your entire family can participate too! To begin, head out to the hardware department.

Once there, buy half a square foot of a sheet of copper flashing, an electric stove, a large mouth bottle, glass or plastic (5 litre mineral jar), a sensitive micro-ammeter, few table spoons of table salt, tap water, sand paper or wire brush on an electric drill, metal shears and three alligator clip leads.

Next, heat stove on high and put copper sheet on it. The sheet will turn into an orange, purple, red or pink color; soon you will see these colors disappear and the sheet darkens. In this manner, the sheet should be BAKED for 30 minutes.

Once this is complete, let the sheet cool off without inducing the cooling process. It will be seen that the sheet is getting smaller. Flaking of the chemical deposits will be seen at this point.

Upon completion of this process, the sheet has to be cooled off at room temperature. You will notice that it is reducing in size as it gets to a normal temperature. It is during this process one see the accumulation of the dry bits of chemicals on the sheet.

Now, cut another piece of the copper sheet keeping the same size at the first one. Place the two in the bottle whose neck is cut. The sheets should not come in contact with each other. The portion of the sheet that faced up while being heated on the stove must be kept facing outward in the bottle.

Now, attach your clip leads, one to the new copper plate, and one to the COOKED one. The clean sheet should be attached to the positive side of the meter and the cooked one to the negative.

Stir many table spoons of salt into hot tap water and ensure it dissolves entirely. Empty this mixture into the bottle while ensuring that the clip heads remain dry. Allow the sheets to be above water for up to an inch. Your first homemade solar battery is complete!

Of course, do not think that it will light up a bulb or something like that. This unit generates only 50 micro amps at 0.25 volts. Ways to use this can be as a detector of light or light meter. To light up an entire home would require the manufacture of hundreds more of such batteries. That would come to a huge expense.

Ready to build your own solar panels with Green DIY Energy and start saving money? Then you need to get the full scoop at the Green DIY Energy review and decide for yourself. Start your solar panel project today!